Help with Qsig Tie line

[EchoSpark]

I am having trouble with a qsig tie line in BC11.It is connected to Avaya PBX.There are no alarms.

Right now, i can make calls from the MD110 to the Avaya if i am not too fast in dialling my digits. If i dial a number to that location, say 3202,very fast on the keypad of a phone, i get back a continuous tone (after dialling the 4 digits). Also, if i press the redial button or i press *** which implies external redial, i get a continuous tone. The normal thing should be that whenever i make a redial ,the last number should be redialled.
I think the router is slow in accepting the digits sent or there is a delay in dial tone gotten back from the router (maybe the pbx has sent all the digits before getting a tone from the router).
Is there any timer either system wide, or for a route - I am not sure which) to delay output of dialing. Like delay start of output and maybe delay between digits?.

any ideas pls.

 

[haja]

Hello Echospark,
I am having also a qsig tie line in BC12.It is connected to Avaya PBX.I have no problems.I am using the next parameters

ROCAI:SEL=711000000000001,TRM=5,SERV=2110000001,NODG=0,DIST=30,DISL128,TRAF=151515,SIG=011110000031,BCAP=111100;

RODAI:TYPE=SL60,VARC=00000310,VARI=15400000,VARO=06400000;

 

[EchoSpark]

Thanks a lot.i'll try this.

 

[EchoSpark]

Hi Haja,

Thanks for your help.The problem has been resolved. DID(direct inward dial) had to be set to Yes on the router.