I have ns500 full capacity I need to add ns1000 To make 150 IP phones A backup has been taken from ns500 Then change to slave When I restore the backup to ns500 or ns1000 does not accept
I tested it in our labs and you can't restore old backup into NS500 which is a member of One-Look network
But you can export data from the old backup and import it into NS1000 ( Mainetenance / Tool/ 7. Export and 6. Import )
That's most of the data, and the rest you have to manually set
Important:
- NS500 must hold IP address
- SIP-EXT and IP-PT cards must be OUS
- NS1000 must be empty (without any cards)
- NS1000 must have the same numbering plan
- register new IP phone to IP sddress of NS1000
- backup old OGM messeges and upload it into NS1000
There are no stupid questions, there are only stupid answers!
Ok
In the current situation 50 ip phones in ns500 but after change to slave
Then run ns1000 with DSP ns0111 128 ip / ns500 with DSP ns5111 128 ip..
How is programming done?
50 ip phones to ip pbx ns500 192.168.1.110
170 ip phones to pbx ns1000 192.168.1.210
220 will work ip phones
+ Recording all pbxs ns500 and ns1000 + PRI 30 in ns500
Can you give an example of how the step by step works?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.