Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Help Request- access code problem

Status
Not open for further replies.

kanwalx

MIS
Dec 20, 2010
19
PK
Hi i have 02 site connected with CISCO (E1) router using E1.
61c rls 4.5 and 11c rls 5.0. I have made 02 TSC (also tried DSC) code at 11c site so that at 11c site user may use trunk lines of 61c. I cannot get dial tone after dialing TSC (or DSC) how ever if i dial number after TSC code i get call connected OK. DLTN=YES in LD 86 also dont giving dial tone to 11c sites users.
Can somebody help in this???
 
Are you dialling the ACOD (AccessCode) of the trunks/route
remember with no TARG/TGAR match directly ?

Cheers!!
 
I am dialing AC2 and not getting dial tone. I also tried route access code and still no dial tone after access code but if i dial the outside number i get through and call gets OK..it is the dial tone giving problem, user should get dial tone after dialing access code...in LD 86, ESN, DLTN is already yes.
Can some body help how can i enable dial tone??
Regards
 
Are you saying you don't get tone, just dead air when dialling AC2 or ACOD ?

or is it a different dial tone you are after to distinguish

Cheers!!
 
Hi kanwalx,

did you programmed the dtad in LD 56?

LD 56

chg
dtad
ddgt (your TSC)
TONE SRC 1



Meridian, Callpilot, CCM (Symposium) from Germany
 
Hi Guys, Sorry for delayed reply, I get dead air after dialing AC@ at remote extension, let me explain a bit more, Nortel PBX is tied with a CISCO Router using E1. an analog extension is connected with FXX/FXO port of that router. When that extension dials AC2 to reach Nortel PBX trunk it gets dead air however dialing nay number after 9 gets OK. Locall extensions on Nortel PBX getting dial tone after 9 but the analog extension connected with FXX/FXO port of cisco switch wont getting dial tone after AC2.

Regards
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top