Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

help op81c to cisco

Status
Not open for further replies.

phnguy

Vendor
May 19, 2005
37
US
can someone explain how to set up cdp? what load? i also have three exts that when i dial them they need to go across to the cisco. i was going to build qsig but that feature is not turned on. any help would be appreciated....
i have an opt 81c 3.0 dchan on msdl
 
Steps to make CDP

1 - Need the trunk route number
2 - Build "Route List" (possible routes to pass call) in LD86
3 - Build extn (or leading digits of extn range) in LD87.

GHTROUT.com | FAQs | Recent Replies
 
ghtrout, thanks for the reply, that's what i needed...thank you
 
qsig works clean but iptrunks are better..

john poole
bellsouth business
columbia,sc
 
yes they are, well i finished the software, then tested and it worked.....thanks for the help
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top