Help New install phones wont ring! 1

[thephoneguyjoe]

HELP Please. New install (8 hours old), ACSR7, 308EC, 400 EC, R3 Large, Bogen Paging Amp on Line 5, new 34D's and 18D's. All new equipment.

Initially set up system and all lines rang normally, but I have screwed up something(s). The incoming line button lights but, the phones don't ring.

The intercom buttons go right into dialtone and if you press 9 you can dial outside. I just want regular intercom tone and use.

I haven't even completely set up the system and I can't seem to back out of this condition(s).

When I pull the VM card, it goes back to normal. What have I done wrong???

 

[whender]

Did you accidently put extentions in call group 7? Preferred line an be set on each telephone. Also, what about night service or button?

 

[skip555]

pull the batterys , cut the power wait a few minutes then start again .

 

[1043]

Assign extensions 78 and 79 to voicemail.

Feature 00
left intercom
left intercom
#505
group 7
extension 78
1 assigned
#505
group 7
extension 79
1 assigned
feature 00

Every other extension (from 10 to 57)should be set to 2 not assigned.

 

[thephoneguyjoe]

Thanks guys for answering on a holiday weekend.

I did a retart but didn't pull all batteries and the backup. I will on Tuesday when I go back in. I don't remember programming anything but 78 & 79 into #505 but I will verify.

Thanks any additional comments are welcome!

 

[skip555]

I make it a point to go through hunt group 7 to be sure it only has the ext I want .

 

[ddools]

centrex on the line from the telephone company?