Help!, geforce 4 mx 440 monitor problems

[Guest_imported]

i have a new ge force and i slot in the card in the slot and attach the monitor adapter 2 it, but the monitor will not turn on !! i put it in my m8's ccomputer and it worked fine, i used his system and my monitor and it worked, but my system and monitor it wont pick up

AMD Duron 1000
19gb
15"intelli scan monit0r

someone help me

 

[gargouille]

I couldn't get it to run with an MSI K7T266 Pro2 RU system I built either...gave up and went to a Ti chipset card...which flies.
Found out it's a voltage issue with the MSI board...perhaps same with you?
What's your motherboard? (same as your m8's?)

 

[tastewart]

Try your m8's monitor on your setup.... I had a similar problem with two new KDS monitors. Work fine on other systems but not with my geforce 4. Different monitor works fine.

If I rebooted several times, I could get the KDS to detect a signal and boot. Then everything looked great! But who wants to mess with that?

 

[gargouille]

Hi tastewart:
Just a friendly bit of advice to a new user...
Note the date on the thread you're replying to.
If it's from a long time ago the person must have fixed the problem and moved on.
There's another indicator of whether the thread is alive (as in current)...and that's to see who marked the thread...as you can see the original poster hasn't marked the thread for notification so it's even doubtful that they'll see your reply.
Please don't mistake my comments as criticism, but accept them as a suggestion for improving the forum.
Please note, that I'm nobody, just another user of this forum!
I always (as a regular) am surprised by a response on an outdated thread and this is usually the case.

 

[tastewart]

Thanks for the advice...... where do you find WHO has marked for notification?

I also responded to this older post because someone searching the net may find the answer they were looknig for....even if the originl poster has moved on.

Thanks again...

 

[gargouille]

Upper right:
Who's marked this thread