Help for Cisco 2600 Router Set Up For Home Lab

[mjb6x3]

I need help for my Cisco 2600 Router i am Setting Up For a Home lab/use i just bought a NM-1E1R Module
i was told i needed it to feed internet to the 2600 router from my ISP but when i go into the CLI I cant see or enable those ports on the module here is my set up
before i added the NM-1E1R Module i had 4 ports

Ethernet 0/0-
Ethernet 0/1-
Console
Aux

The Module has added these ports

Token Ring 0

Ethernet 0


please help me how do i get my router to connect to my home router

 

[lerdalt]

I'm not sure why your ISP would have told you to that you needed that extra module. I have a 2600 running at home with 1 ethernet internet connected to the cable modem, and the other connected to my internal LAN.

The interface I have facing my cable modem, is setup to get a DHCP address from the ISP, and then I have setup NAT to allow everything outbound.