Hello! I temporary connect two Avay 1

[OlegPowerC]

Hello! I temporary connect two Avaya CM by H.323 trunk.
In first station I have two E1 trunks.
In second station I have phones only. For call between this phones I set FRL то 1 on my H.323 trunk.
But calls to outside do through ARS and multiple route pattern with different FRL. When I want call to outside from second station, call go to trunk 1 to primary station but after route to ARS I get message about low FRL.
What can I set FRL for call from trunk 1 ?
PS:
If You do not understand my scheme, try to describe:
I have CM6 and deploy new CM8. I move part or my phones from 6 to 8 and set this extension in dialplan to AAR and go to trunk 1. In second station CM8 I set all calls to AAR but outside calls through route patterns with different FRL.

 

[kyle555]

CM2 calls via it's trunk 1
That call hits CM1 on a trunk group. Perhaps it also is trunk group 1.

CM1 sees the digits that it wants to send to ARS to a route. It is the FRL of the COR of the CM1 H323 trunk group that will be analyzed. Make that FRL 7

Or, just try FRL 0 for some test routes dialing out the E1s.

 

[OlegPowerC]

Thank You!