HDU7/1 problem

[cpux10]

Hi everyone,
I am trying to use an HDU7/1 board with NIU2 as my primary storage device. I have a number of HDU7/1s which I have tried with, and I face a problem with some of them (its OK with the rest)
After I do FIMOE and IOSIE and remove the previous HDU/CF, when initiating the new HDU, I get this error:

<IOSII:NODE=SYSN,IODEV=SYSDISK1,BTYPE=ATA,SUBFS=SYSSUBFS11&SYSSUBFS21;
NOT ACCEPTED
NO DISK IS CONNECTED

I have tried turning on/off the HDU, restarting the NIU2 board etc. but doesn't help.
Does anyone have an idea?

 

[RFEXI]

Have you checked the SCSI address on the HDU?

 

[RFEXI]

Do you use SCSI Terminator on the hdu?

 

[rfpui]

Hi RFEXI

SCSI for ATA disk??????

----------------------------------
If anything can go wrong, it will.
(Murphy's Law)

 

[RFEXI]

sorry, i thought it was scsi.

 

[asuvp]

How long is your cable?

 

[cpux10]

20 cm
Its the standard TSR 901 0441/200 cable.

 

[hdemir]

hi cpux10

check the flash disk on the niu2 board.

 

[cpux10]

The flash disk?
I don't want to use flash disk. I want to use HDU7/1 instead.
BUT I have tried to use the HDU7/1 as backup with the CF used, but I still get the same error.

 

[fouesnant]

Hi

Have you tried to connect via NIUX and perform the command :
atmft 0
This command suppose that the HDU7/1 is connected as master and that you don't have CF placed on the NIU2 board.

 

[fouesnant]

this command is supposed to format the disk, so if you need to keep the data stored on it, don't use it...