C2522 has 2 MB mem & 8MB flash, IOS 11.2 (12.x won't do as it requires 16MB of flash)
I've previously set up Frame switching on a 1750 with 2 x WIC 1T, routing the DLCI attached on s0 to s1 & routing DLCI on s1 to s0,no problem works a treat. However when I try to set more than one DLCI routing command I get an error, this is a sample of the problem (configuring s0)
"2522_Frameswitch(config-if)#frame-relay route 100 int s1 200
2522_Frameswitch(config-if)#frame-relay route 100 int s2 300
Can't use same dlci on overlapping circuits"
DLCI 100 is (or will be) attached on s0, 200 on s1, 300 on s2.
I'd like to to set up R1 (attached to s0) as point to multipoint & the remaining routers (attached to s1-s4) as point to point with s0, but it seems as if I've fallen at the first hurdle.
I've had a look on the Cisco forum & there are one or two posts about this, even have a config for aggregating 2 routers & creating a GRE tunnel via their AUX ports, but that doesn't fit my needs.
So your mission should you choose to accept it, is to help me to resolve my issue (or at least explain why it can't be done). Thanks in anticipation
I've previously set up Frame switching on a 1750 with 2 x WIC 1T, routing the DLCI attached on s0 to s1 & routing DLCI on s1 to s0,no problem works a treat. However when I try to set more than one DLCI routing command I get an error, this is a sample of the problem (configuring s0)
"2522_Frameswitch(config-if)#frame-relay route 100 int s1 200
2522_Frameswitch(config-if)#frame-relay route 100 int s2 300
Can't use same dlci on overlapping circuits"
DLCI 100 is (or will be) attached on s0, 200 on s1, 300 on s2.
I'd like to to set up R1 (attached to s0) as point to multipoint & the remaining routers (attached to s1-s4) as point to point with s0, but it seems as if I've fallen at the first hurdle.
I've had a look on the Cisco forum & there are one or two posts about this, even have a config for aggregating 2 routers & creating a GRE tunnel via their AUX ports, but that doesn't fit my needs.
So your mission should you choose to accept it, is to help me to resolve my issue (or at least explain why it can't be done). Thanks in anticipation