Hardware to PRI Instalation in 0x32

[mksanchez]

Hi, everyone I install in a 0x32, with T1 cartridge NT7B74AAAA , 2 port fiber NTBB02 , and a service cartridge NTBB24 , it´s this sufficient , or need some extra, I Install with a encore sp201 two ports,


For your help Tanks You

 

[BlackCuervo]

Is this T1 card the DTI? Are you going to install it as a T1 or PRI (E1)?. If your answer is yes and if your MICS is a 7.0 or greater, I can tell that you don't need anything else.

 

[exsmogger]

If you have R4.1 or higher software in the 0x32 and a PRI enabler keycode installed you are good to go.

Brian Cox

http://www.jandjcommunications.com

 

[mksanchez]

Thank you for your answers, the software is a R6.1 , in this version i need a PRI enabler keycode installed ? to work the pri lines (I changed to PROFILE 2 the system)

Thank You!

 

[BlackCuervo]

No, you just need to go to Hardware, then go to the trunk module, and change your type of card to PRI.

 

[mroberts]

PRI installation was allowed beginning with 4.0 software. So 4.0 and higher you can install a PRI circuit.

REGARDLESS of the software level, you MUST have a PRI enabler code to be able to go into hardware and change the card setting to PRI.

MRoberts

http://www.a1teletronics.com