Hardware replacement IBM/Brocade SanSwitch

[svnhunix]

Hello

had a defect sanswitch in my fabric. IBM replaced it and all feature keys are regenerated. I configured the same switch id as the previous one and try to reintegrate the switch into the excising fabric. It seems that this does not work that simple.
Fabric reintegration does not occur. On the active fabric sanswitch I see the following message: EFP rejected: EPORT isolated

What is the procedure to reintegrate a replaced sanswitch into a fabric? Anyone done this before?

best regards
Steven

 

[p5wizard]

FOS or EOS version mismatch?

HTH,

p5wizard

 

[svnhunix]

Found the solution. Apparently I had to reboot after adding the fabric license... I didn't know that.