H3C S5120-SI 802.1q qinq setup

[MayfairBlues]

Hi

Trying to enable basic qinq on the H3C S5120 switch. Couple of question can you do this on the non enterprise version? Secondly can it be done via telnet session. Telnet rights is level 3, command used (but fails) qinq enable.

system-view
interface gigabitethernet 1/0/17
qinq enable

after that it responds % Unrecognized command found at '^' position.
^ is the letter q at the start of qinq enable

 

[merrym]

Well, it´s simple. QinQ is not supported on S5120. I think you need at least the S5500 was it -EI(?) series for this

 

[MayfairBlues]

After eventually getting through to H3C support they confirmed the with software update then qinq is supported.

 

[merrym]

Seems I was wrong, sorry for this.

According to 5120SI-CMW520-R1505P07 Release Notes QinQ is supported.