h323 trunk adc 1

[bioser]

hello i try trunk h323 with mxone and pnasonic solu and use this command
ROCAI:ROU=x,SIG=011111100091,SERV=0110000007,SEL=0110000000000010,TRAF=03xxxxxx,TRM=6,BCAP=001100;

RODAI:ROU=x,TYPE=TL65,VARC=00000001,VARI=00000011,VARO=00000000;
executed
RINII:BPOS=x-x-xx,GRP=1,IP=192.168.1.1,MASK=x.x.x.x[,ROUTER=x.x.x.x][,ETHCNF=x];
executed
RIANI:ROU=x,GRP=1,IP=192.168.1.2,LROUID="NodeA",RROUID="NodeB"[,CODECS= ];
executed
RODDIEST=xx,ROU=x,IP=192.168.1.2,SRT=x,RROUID="NodeB",ADC=0626100000000050006000000;
adc not in range

adc parametr in invalid can help me ?

 

[Monrovia]

Hi

dont u miss 2 digits in ADC?

BR
Monro

 

[bioser]

thank you for your reply and can you more explain about
,LROUID="NodeA",RROUID="NodeB

 

[Monrovia]

Hi

from ALEX

LROUID= Local route identifier.
The parameter states a route identifier used to distribute the incoming H.323 traffic. Incoming calls are distributed to that route whose local route identifier matches the route identifier received in the call.

At the same time, the identifier is used to authenticate if the incoming H.323 traffic comes from a known source.

RROUID= Remote route identifier
The parameter states the remote route identifier to be conveyed in the outgoing H.323 traffic.

If the remote node is another ASB 501 04, this identifier is used to distribute the incoming H.323 traffic. The identifier is compared with the local route identifiers defined for H.323 routes at that far end until a match is found. Then, the call is distributed to that H.323 route
-----------------
Since you are connecting to Panasonic, you may avoid these 2 parameters in MD. These are just texts to identify the route, from where to where; you can put any text like, LROUID = MD110 & RROUID = Panasonic.

BR
Monro

 

[bioser]

thanks for your help