h323 more explain 1

[zagali]

I want to know where the target server is ip should I use codec and what can someone explain to me? and adc in md110 is 25 parametr but in tsw 27 parametr two bit ltes ????
RINII:BPOS=X-X-XX,IP=A.B.C.D,MASK=E.F.G.H,ROUTER=I.J.K.L;
ROCAI:ROU=50,SEL=7120000000000010,SERV=3110000001,TRAF=00151515,SIG=011100100091,TRM=7,BCAP=111111;
RODAI:ROU=50,TYPE=TL65,VARC=00000111,VARI=00000001,VARO=00000000;
ROEQI:ROU=50,TRU=1-1&&1-32;
RODDI:ROU=50,DEST=X,ADC=0606100000000250006000000,IP=W.X.Y.Z;
RIANI:ROU=1,GRP=1,CODECS=B;

 

[nerdherder27]

HI,
with command RINII you config your board ip address.
with command RODDI you config destination of trunk (ip= target server ex. another MD 110 or BP 250 or another target vendor)
important: with command ROCAI at SIG last digit 1 you config if the protocol h323 is Ericsson or not (with dig=0).

ex. trunk h323 with CISCO CUCM I config sig with last digit at sig = 0

 

[zagali]

and adc in md110 and tsw??? why 7 paraMETR AND 25 PARametr?

 

[zagali]

hello i config iplu board before fro ip ex use and riini not accept
how do i?

 

[zagali]

IPBOI:BPOS=1-3-40,IP=172.16.12.2,GATE=172.6.12.1;
LATES CONFIG FOR IP EXTENTION

 

[nerdherder27]

You want use IPLU board for ip-extension or ip-trunk?
for ip-extension you use command IPBOI (ACTIVED GATEKEEPER H323) IPBOE (DEACTIVED GATEKEEPER H323)
for h323-trunk you use command RINII (actived) RINIE (deactived)

the iplu/elu32 board you can use or for extension or for trunk it's not possible use for both.

ADC is a paramater that configure at command RODDI in this parameter you configure the type of cal ex. national,private,Unknown, international...ecc..

 

[zagali]

THANK YOU SO MUCH FOR YUOR GREAT HELP

CHEERS

 

[zagali]

i do that just is a problem from ericsson i can call to asterisk but from cisco call not established