H.323 FXO Pots Configuration 1

[hanluc6933]

Hello All,

I am trying to find an example H.323 build for a POTS line connected to a FXO port. This will be used for inbound and outbound calling. This is currently setup using mgcp however, the caller-id is not functioning correctly and the fix is to go to H.323.

I was hoping someone could point me in the right direction on finding the correct dial-peers and voice-pots configurations to use to complete this tasks.

Thanks again!

~Han

How would I describe myself? Three words: Hard-working. Alpha-male. Jackhammer. Merciless. Insatiable. ~D. Schrute

 

[andyjreed]

This one hasn't been answered, and I actually have the same question too...

 

[whykap]

Here is a link that should help you out.

http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/dial_peer/dpeer_c.html

 

[hanluc6933]

Thanks whykap, I did end up get this going last week. Andyjreed, the doc that whykap provided has all you need to complete the configure.

Do the day and let the day do you.

 

[andyjreed]

Ohhhh.....

So basically, it's the same setup as if I were setting up POTS lines for use with CUCME, but the router also needs to be set up as a H.323 gateway, and then point the CUCM server to the gateway?

 

[whykap]

You got it.