GSFTI

[TheCurious]

GSFTI gives me response like this:

GSFTI:GSM=0,GSSIDE=0,TEST=SLOT;
GROUP SWITCH MODULE TEST
FAULTY TIME SWITCH = 0 GJC = 0 TIMESLOT = 18
FAULTY TIME SWITCH = 0 GJC = 3 TIMESLOT = 4
FAULTY TIME SWITCH = 0 GJC = 3 TIMESLOT = 6

One minut later response is like this:

GSFTI:GSM=0,GSSIDE=0,TEST=SLOT;
GROUP SWITCH MODULE TEST

EXECUTED

Is Group Switch really bad?

 

[SYAR2003]

It can be variable disturbances from ground or something .

...

 

[rorni]

Hi,

Check with command "gjlsprint=faulty".
You should send it twice : first printout will erase the log. The second printout will give you active errors.

Post the second printout here for further analyse

Regards
/rorni

 

[TheCurious]

GJLSPRINT=ALL;
GROUP JUNCTOR LINE STATUS
EQU = 3-0-00-0 GS-MULT 0-0
GS SIDE 0 ACTIVE ACTIVATED SIGNALLING SYNC RECEIVING
SIDE 0 ALARM 0000 0000 0100 0000


EQU = 2-0-00-0 GS-MULT 0-1 RCCL
GS SIDE 0 ACTIVE ACTIVATED SIGNALLING MASTER LINK
SIDE 0 ALARM 0000 0000 0100 0000


EQU = 1-0-00-0 GS-MULT 0-3 MCCL
GS SIDE 0 ACTIVE ACTIVATED SIGNALLING CLOCK CONTROL
SYNC RECEIVING
SIDE 0 ALARM 0000 0000 0100 0000


EQU = 5-0-00-0 GS-MULT 0-10
GS SIDE 0 ACTIVE ACTIVATED SIGNALLING SYNC RECEIVING
SIDE 0 ALARM 0000 0000 0100 0000


EQU = 4-0-00-0 GS-MULT 0-11
GS SIDE 0 ACTIVE ACTIVATED SIGNALLING SYNC RECEIVING
SIDE 0 ALARM 0000 0000 0100 0000

By the way, system is BC9.B

The Curious

 

[LME]

Hi
You have an alarm BIT6 "incomplete clocking in group switch".
Run the following command
SCICI:MCCL=0-3,RCCL=0-1,ACCL=0-0;
SCICP;
Run gjlsprint=all twice and alarm should be
removed.