GJUL4 link wothout GS

[ExtensionManager]

Hi All,

I have a 2 Lim BC9 system working with a GJUL4 link without GS.
Now I bought another 2 GJUL4 cards.
Is there any limitation where to put GJUL4 card in both LIM?
I mean of course it must be a 32 TS slot, but do they have to be on the same position (1-1-00<->2-1-00)?

The existing GJUL4 cards are working this way.
Is the GJLII the right command to make work the link?

When I see GJTSP, some EQUs are connected to itself, is it normal?

Thanks in advance!

 

[ButtonIt]

As long as all 32 timeslots are free you can put a GJUL board anywhere, they don't have to be the same at either end.

So you could put one in 1-2-00 and the other in 2-1-60 if you wanted.

 

[md110user]

In a two LIM system without a group switch only the parameter EQU is required. The parameter GSMULT is optional, but omitting it will result in a random value. To gain information about selected value on GSMULT. In this type of configuration the connected GJU-L boards in both LIMs must have the same equipment position. The PCM-line must be initiated in both LIMs.

 

[md110user]

By the way the maximum number of GJUL4 per lim is eight &quot;8&quot;.

 

[Radoje]

Hi Extension Manager !
You should put GJUL4 boards in same position in both LIMs. Once I did not take care about this rule and I could not do the backup on HDU. Backup always stopped at one of the program units.
Try it yourself...

 

[ExtensionManager]

After putting the cards on the same position it looks working.

But I got the alarm for the new card:

115 SIGNAL PACKET LENGTH REDUCED
DATE TIME ALP NOIF EQU BRDID INF1
16JUN03 08:49:03 1 1 001-1-00-00 36 1

What's this?



And also strange this:

<gjlsprint=all;
GROUP JUNCTOR LINE STATUS
EQU = 1-0-00-0 GS-MULT 0-0
GS SIDE 0 ACTIVE ACTIVATED SIGNALLING MASTER LINK
SIDE 0 ALARM 0000 0000 0000 0000


EQU = 2-0-00-0 GS-MULT 0-1
GS SIDE 0 ACTIVE ACTIVATED SIGNALLING SYNC RECEIVING
SIDE 0 ALARM 0011 0010 0000 0000


EQU = 1-1-00-0 GS-MULT 0-6
GS SIDE 0 ACTIVE ACTIVATED NOT SIGNALLING NO CLOCK CONTROL
SIDE 0 ALARM 0010 0010 0000 0000


EQU = 2-1-00-0 GS-MULT 0-7
GS SIDE 0 ACTIVE ACTIVATED NOT SIGNALLING NO CLOCK CONTROL
SIDE 0 ALARM 0010 0000 0000 0000



Not signalling, No clock control?
Any idea?

Thanx,

EM

 

[eriuser]

Only one link per LIM has Clock control and again only one link is signalling. This is not a problem, should the signalling/Sync link fail the other will take over these functions.

The second link will be taking traffic, you can check this with the command LSCOP:LIM=1; this shows internal connections and will include some to the GJUL cards.