When I used hyperterminal I could get to "User EXEC" mode, when I try to connect now I get a "Username :" prompt and cannot get back to "User Exec" mode.
Well.. you didnt leave a model number but you have two options. ONe is to use SNMP *if* you have the RW option in place to download the config, tweak it and upload it. The other is to use the correct password recovery technique. Apparently someone turned on authenticaition which means it's looking for a special server to check the user ID and password. Whoops!!!
Mike S
"Diplomacy; the art of saying 'nice doggie' till you can find a rock" Wynn Catlin
Sorry, it's a 3640, which has been removed from a network to do a memory upgrade. I thought I would check if the upgrade was successful before returning it to the network. It is configured to use a radius server for dialin authentication.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.