Getting the following error message when trying to install 'Print Artist' by Sierra Software on 'NT Workstation 4', 'Integer divide by 0'. The System comprises of an Intel Pentium III 800Mhz,256MB.Ram,Intel 815EAL Motherboard, 2 X 20GB.Quantum IDE Drives, Philips IDE CD-Writer, 250MB. Internal Zip,40X SCSI CDRom Drive,HP DAT Drive which is also SCSI,Adaptec AHA-3922 SCSI Card. The program works fine in NT on a P II 300Mhz PC????????
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Getting the following error message
- Thread starter seagor
- Start date
I'm not sure about the "print artist" install, but for a long time, sierra was known for faulty hardware tests. Usually there is a way to tell it *not* to check hardware and just install. If you can find this, i bet it will install fine.
David Moore
dm7941@sbc.com
David Moore
dm7941@sbc.com
- Thread starter
- #3
- Status