Getting Started with ASBCE Portwell CAD-0230 Help 2

[dsm600rr]

Hello all,

I just received my ASBCE Portwell CAD-0230 and reading through some documents I am not really sure where to begin.

The ASBCE shipped with a R8.1.1 USB Thumb Drive however the documents indicate the software should already be installed.

I only get a Link Light in M1 Port so I am assuming that is the management port.

How do I log into this thing?

Also a bit confused on EMS

ACSS

 

[dsm600rr]

G van Hamburg: Appreciate it. Can you review my settings:

ACSS

 

[G van Hamburg]

Yep, looks good! Next step is to add signaling ports and media ports. if you use TLS, add some certs first.

Freelance Certified Avaya Aura Engineer

 

[derfloh]

The next steps are described in the IPO ASBCE doc.

IP Office remote service
IP Office certificate check
CLI based call blocking
SCN fallback over PSTN

 

[dsm600rr]

derfloh: Which one? I have been following:

Avaya_SBCE_Administering_8.1.x_December_2020.pdf (630 pages)

Avaya_SBCE_Deploying_on_a_Hardware_Platform_8.1.x_December_2020.pdf (121 pages)



ACSS

 

[derfloh]

This one:

https://support.avaya.com/css/P8/documents/101065744

IP Office remote service
IP Office certificate check
CLI based call blocking
SCN fallback over PSTN

 

[dsm600rr]

Hello everyone,

Few more questions. Seems like every morning I have to re-boot the ASBCE to gain access to EMS GUI.

I also am getting these errors on boot:

ACSS