Get rid of Deleted Sub-Interfaces?

[andrew4728]

Hey all, me again with my Cisco 2514.

I was messing around with Subinterfaces, and I created some sub interfaces. After I was done, I deleted them, but they still show up in my IP INT list. Anyone know how to clear them out, without rebooting the router?


R1#sh ip int br
Interface IP-Address OK? Method Status Prot
ocol
Ethernet0 x.x.x.x YES DHCP up up

Ethernet0.1 unassigned YES unset deleted down

Ethernet1 192.168.0.33 YES manual up up

Ethernet1.1 unassigned YES unset deleted down

Ethernet1.2 unassigned YES unset deleted down

Ethernet1.10 unassigned YES unset deleted down

Serial0 192.168.2.1 YES NVRAM down down

Serial0.1 unassigned YES unset deleted down

Serial1 unassigned YES TFTP administratively down down

Virtual-Access1 unassigned YES unset up up

All I want in the list is the E0, E1, S0, S1, and Virtual-Access1.

Any clue how to remove the DELETED entries from my SH IP INT ?

Thanks !

Andrew

 

[ADB100]

It takes a reload of the router to clear these.

Andy