I have a general scenario that I need to setup, but I just wanted to get pointed in the correct direction before I put more time into it.
I have two sites that need to be connected. There was a T1 run between the two sites for this purpose. I have two cisco routers (1602 w/T1 card & 1720 w/T1 card) that will be doing the work.
SiteA has a connection to the internet and a Windows domain. SiteB will need to access the internet through SiteA's connection, and will need to be able to have access to SiteA's LAN. SiteA will also need access to SiteB's LAN. Basically, the only reason for the cisco routers is facilitate the T1 line, it's not going to be doing routing or anything.
I believe the router setup should be pretty easy, but I'm not sure where to start. How would I set the routers to pass through everything.
I have two sites that need to be connected. There was a T1 run between the two sites for this purpose. I have two cisco routers (1602 w/T1 card & 1720 w/T1 card) that will be doing the work.
SiteA has a connection to the internet and a Windows domain. SiteB will need to access the internet through SiteA's connection, and will need to be able to have access to SiteA's LAN. SiteA will also need access to SiteB's LAN. Basically, the only reason for the cisco routers is facilitate the T1 line, it's not going to be doing routing or anything.
I believe the router setup should be pretty easy, but I'm not sure where to start. How would I set the routers to pass through everything.