Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

GATM8 problem on BCM 50 rls 2

Status
Not open for further replies.

mohdhy

Vendor
Mar 14, 2007
30
JO
hi guys.....

i have a bcm 50 rls 2 with two expansions (DSM 32+ & GATM8),
i did install the system and configure it ; the dsm 32+ is working well ...but the problem is in the GATM8 , when i configure it, on the telephony resources its enabled , but when i check the active physical lines it doesnt show any line ..any one can help
 
Have you tried swapping the MODs


This is a Signature and not part of the answer, it appears on every reply.

This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.


 
yes , i did install the keycode and tried to swap the Modules; the dsm32+ works well on the both chassis
 
I reread this and i'm not sure what you meant or how you were checking it.

" but when i check the active physical lines it doesnt show any line"


This is a Signature and not part of the answer, it appears on every reply.

This is an Analogy so don't take it personally as some have.

Why change the engine if all you need is to change the spark plugs.


 
I'm sure you've done it. But, try disabling and then reenabling the GATM8
 
On a BCM 50 you do not change the switch settings but I would check them to make sure nome have been bumped or it was used in a 400 once.
 
hi guys ,
i have a new chassis and the problem is solved

thanx
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top