G700 - MM710 board config 1

[nnickgm]

Do MM710s have the following settings? If so where are they found.

Framing
line coding

I need to check them against the IAD that is connected to it via ethernet.

I am experiencing slip seconds on the T1 line, and from what we've looked into so far it does'nt seem to be the IAD.

 

[98Converter]

You need to display the DS1 itself...

Thanks,
CJH

We are what we repeatedly do. Excellence, then, is not an act but a habit. ARISTOTLE 384-322 B.C.

 

[nnickgm]

How would I go about displaying the DS1?

 

[98Converter]

list conf ds1 on your PBX. Locate the slot were the MM710 is. Should be something like

030V2 MM710AP HW05 FW020 isdn-pri PRI 1 n/a

Then type: display ds1 30v2

Thanks,
CJH

We are what we repeatedly do. Excellence, then, is not an act but a habit. ARISTOTLE 384-322 B.C.

 

[nnickgm]

Thanks man,

That did the trick