Can anyone tell me if it is necessary to configure the standby LAN port ip address when using port redundancy on a G450? For example, if the primary port is 10/5 and the secondary 10/6 does port 10/6 need to be configured with ip addresses etc or does it automatically take on the same values as 10/5. If 10/6 does have to be configured can it have the same ip address as 10/5? Thanks in advance, Paul.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
G450 Port Redundancy
- Thread starter CF831SR
- Start date
If you configure 10/6 as redundant, it will take on the IP Address assigned to the VLAN, default is 1. The ports are configured as active/backup when redundant.
The command would look like this:
set port redundancy 10/5 10/6 on "1"
*Note: whatever is in the quotes is just a name, you can put whatever you want in there.
The command would look like this:
set port redundancy 10/5 10/6 on "1"
*Note: whatever is in the quotes is just a name, you can put whatever you want in there.
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question
- Locked
- Question