G450 & S8300 Setup

[damage750]

I've got an Avaya G450 with a S8300 here that I'm looking to setup for testing purposes. It will not be in production so there is no worry about downtime.

I'm trying to get in to add analog stations on the MM711 cards, however whenever I access the integrated management by the services port or on its LAN IP, I cannot get into Avaya Device Management to add stations. I can pull up the GUI that shows the system and the modules that are installed, but I cannot access Administer Station/Gateway, or Call Controller. It appears the S8300 isnt registered to the G450 since a show mgc shows nothing registered under call controller or mgc host.

Not too sure what I need to do to get this up and running so any help is appreciated.

 

[damage750]

Nevermind, I got it figured out.

 

[TelecomAnimal]

So what was it?

 

[damage750]

My S8300 wasn't working like it should. It was a defective hard drive and not allowing me access any administration. I put the HD in another card and it had the same issues. I took the known working HD and put it in this card and everything worked fine.