Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

G430 enable interfaces

Status
Not open for further replies.

SirArthur

Technical User
Nov 17, 2008
15
AT
Hi,
How is it possible to enable the FastEthernet port 10/3 & 10/4 on the G430 gateways???

If I want to configure them for backup interfaces I always get the error message (this is the inital configuration):

"G430-???(super)# interface FastEthernet 10/3
BAD 1st PARAMETER (10/3)"

Are there any ideas?
 
you need to use the "set port" commands to enable and configure the physical ports.

PG
 
It is possible to enable the interface with "set port", but even through this activation you will get the inital error message.

It seems that the interfaces 10/3 and 10/4 are bounded to the default vlan 1, but it is not possible to delete/deactivate the vlan or to clear the binding to a vlan.

Any ideas?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top