G350 V7 module

[JayNEC]

Anyone else having problems with the V7 module of the G350? Various things - port going dead and requires a reset of mm v7.
Noise on the V7 Trunk port, but move that CO line to an mm711 board and the noise is not there.
This is occuring across multiple G350's - quite a few in fact.

 

[JayNEC]

So, everyone out there that is using G350's is happy with the V7 module?

 

[phoneguy55]

All my G350's have MM711 boards so I don't use the V7.

 

[YeOldPhoneGuy]

I had had problem the the v7 module in multipe G350's. The analog v7 port would immertimently go "dead". Reseting the port did not bring it back into service. I had to telnet into the g350 and reset it at command prompt. Upgraded firmware and the issue went away. I do not remember what version firmware I put on the g350 but will check and see if I get update you with the version later.

Me

 

[JayNEC]

Nice, thanks for that.

 

[calhoony]

I still have that problem with G350's we are running 24.17.0/1 what firmware level do I need to eliminate this issue?

 

[d3finity]

This should sort you out mate!!


G350 Analog Firmware (Vintage 68) Released February 20, 2006
G350 Analog V68

MD5 Sum = 306b6c96179778e7c9d1e68d564cc9f7 G350 Analog Firmware (Vintage 68) - Supports Communication Manager 3.1.1 and is compatible with earlier releases. See the readme file for details on the fixes included.

 

[d3finity]

oh and here is the latest Firmware for the G350 MGP

regards

G350 MGP Firmware (Vintage 25.23.0) Released February 20, 2006
G350 MGP Firmware
MD5 Sum =
4346b0c714b74f3306ace3328c2ede02 G350 MGP Firmware (Vintage 25.23.0) - Supports Communication Manager 3.1.1 and is compatible with earlier releases. The G350 is not supported on Communication Manager releases earlier than 2.0. See the readme file for details on the fixes included.
G350 V25.23.0 readme.txt Read Me File