G350 sync source

[DontDeleteMeAgain]

what is the command to set the sync source ona G350 CM5.1. it used to be chan sync, but now it's not there, i heard it may be from the cli.

 

[Mitch672]

telnet (or SSH, if you have not run "ip telnet") to the G350

"set sync interface primary v4" (if your MM710 T1/PRI is in slot 4)
"set sync source primary"

you can see if its working with:

"show sync timing"

example below is a G450, G350 and G700 are the same.
--------------------------------------------------------
Client-G450-001(super)# set sync interface primary v4
Done!
Client-G450-001(super)# set sync source primary
Done!
Client-G450-001(super)# show sync timing

SOURCE MM STATUS FAILURE
--------- ------------------- ----------------------- ---------------
Primary v4 Active None
Secondary Not Configured
Local v0 Standby None

Active Source: v4 Sync Source Switching: Enabled

Done!
Client-G450-001(super)#

mitch


AVAYA Certified Specialist

 

[DontDeleteMeAgain]

Thanks Mitch, i'll give it a try tomorrow AM

 

[Mitch672]

no problem, don't forget to do a "copy running-config startup-config" to save the change you made, so it shows up after the next reboot/power down.

mitch


AVAYA Certified Specialist

 

[DontDeleteMeAgain]

where do i find the ip addy to telnet to the root level? i do go shell from the sat interface, but then i cant get to the g350 cli

 

[colby007]

list media-gateway will show the G350 IP address. once in the shell telnet to the address. You'll need the root login and password.

 

[DontDeleteMeAgain]

it's a stand alone, i dont think list media would show anything

 

[Mitch672]

Yes, "list media" will show the IP of the G350, so will "display media 1".

mitch


AVAYA Certified Specialist

 

[DontDeleteMeAgain]

ok, thanks

 

[big70]

Did you at least ad a media gateway?

Also administerd the gateway and registerd it.

http://www.jaymzworld.com/w/images/d/de/G350_cli_ref.pdf

Greets Peter