Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

G350 Install?

Status
Not open for further replies.

Labash

Programmer
Apr 11, 2008
138
US
Trying to install a G350 (without S8300) using IW.
I have installed a G700 using IW successfully registered but this menu is different. On the 700 I progranned 4IP addresses, stack, mgc, controller and Voip.
What IP addresses or other inputs do I need for the 350 to have it register?
Thanks
 
I don't use the IW. For me it's easy enough to do it from the comamd line. The G350 only has 1 IP. They are much simpler than the G700. Make sure and use the set port command to set it to 100/full and don't forget to do a copy run start to save it when you're done.
 
Thanks.
So what is the prompt that is entered to set the IP in the command line?
Any other prompts necessary?
 
Here is the complete G350 CLI commands doc. Just google it.

Avaya G250 and Avaya G350
CLI Reference
03-300437
Issue 2.1
August 2006

also!!

set mgc (you'll have at least one clan ipaddress and sat port 5023.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top