CM4 s8300 g250 latest patch. Run installation Wizard, gateway registers. Then reboot system, it doesnt register again. Have to re-run wizard tocome back up
sometimes you need ro run "configure server" to get the IP data to become permanent (on the S8300 processor). Its a bug, but usually this is only needed once... then try a total system powerdown, and powerup, and it should work... I do this on all systems before I ship them out, I call it the "powerdown/powerup" test, to verify the IP address's and settings have remained.
Mitch672
The IP addresses are not lost. I can log into the g250 and allthe settings are there. I will try the configure server option.
rlance610
Did that and still didn't work
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.