I setup a service_mode command in VMPro to put a huntgroup back in service. I did - CFG:SET "880" service_mode 1 - The problem is that if I change the last value to 0,1, or 2 it puts the huntgroup out of service. I can't change it to night mode or in service with the command. Is this maybe a bug on R9.1 or did I miss a step?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Free format command VMPro 1
- Thread starter 4vayaMan
- Start date
No problem ![[smile]](/data/assets/smilies/smile.gif "[smile] [smile]")
And maybe you should consider making the config from scratch as well, getting rid of old bugs and flaws.
If anyone with ADI login has the time... FK: 1340957747
Kind regards
Gunnar
______________________________________
Mille viae ducunt homines per saecula Romam
And maybe you should consider making the config from scratch as well, getting rid of old bugs and flaws.
If anyone with ADI login has the time... FK: 1340957747
Kind regards
Gunnar
______________________________________
Mille viae ducunt homines per saecula Romam
- Thread starter
- #22
Yes, that's exactly what I'm doing. The two cards that were at 9.0.5 are not even in this system - it's just the UCM and one combo card so they shouldn't even be listed on the config anymnore. Downloading 9.1.1 right now and going to do everything from scratch.
- Thread starter
- #23
- Status