Forcing Stations to use their own location

[noginthenog]

I have set up a new lsp at a remote branch, and for that branch I have created location 2, I have set up a new ARS location table for location 2 and also a new network region for those phones. However when I make a call from station at that new location it isn't using the local trunk and route pattern for the remote branch it is based at. Is there a setting on the station form where that I can tell it what location it is based in? Or is it on the COR or some other form where I set this?

 

[phoneguy55]

set up a IP newtork map and make sure the new ip network region uses location 2.

 

[noginthenog]

Done that and it all works pefectly now, thanks for your assistance