Hi,
I am trying to resolve a problem on my 2600 router and it seems i cannot delete the flash as it wont let me boot into the authentication.
All it does is stop here:
*Mar 1 00:00:19: %SYS-5-CONFIG_I: Configured from memory by console
*Mar 1 00:00:19: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-IS-M), Version 12.0(11), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Sat 20-May-00 10:46 by htseng
*Mar 1 00:00:21: %LINK-3-UPDOWN: Interface Ethernet0/0, changed state to up
*Mar 1 00:00:22: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0/0, changed state to down
Then i wait about an hour and still not a thing.
I would like to delete this flash and re-install a new IOS but it wont let me get into the break sequence!!!! What the?!?!
I am trying to resolve a problem on my 2600 router and it seems i cannot delete the flash as it wont let me boot into the authentication.
All it does is stop here:
*Mar 1 00:00:19: %SYS-5-CONFIG_I: Configured from memory by console
*Mar 1 00:00:19: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-IS-M), Version 12.0(11), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Sat 20-May-00 10:46 by htseng
*Mar 1 00:00:21: %LINK-3-UPDOWN: Interface Ethernet0/0, changed state to up
*Mar 1 00:00:22: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0/0, changed state to down
Then i wait about an hour and still not a thing.
I would like to delete this flash and re-install a new IOS but it wont let me get into the break sequence!!!! What the?!?!