Churchtech
Technical User
I have built tree 1 with 4 paths and saved with no problem. When I go to assign tree to greeting table it says "incomplete tree". Who has the solution?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Flash "incomplete tree"
- Thread starter Churchtech
- Start date
- Status
There is an undefined path in that tree somewhere. The easiest way to find it (especially if there are a lot of paths) is to hook up a pc via a 9-pin connector, open Procomm or Hyperterm, and run a tree report. The error will stick out pretty clearly.........
curlycord
Programmer
One of your 4 paths was probably setup as a Menu and is not truly a Menu.
i.e for list of staff press 4
You then ask people to press Ext #s instead of another single digit choice.
A proper Menu needs at least one single choice.
So expample to fool the path you would go to Path 48 and make it a Transfer to reception.
That 8 is what completes the Tree.
=----(((((((((()----=
curlycord
i.e for list of staff press 4
You then ask people to press Ext #s instead of another single digit choice.
A proper Menu needs at least one single choice.
So expample to fool the path you would go to Path 48 and make it a Transfer to reception.
That 8 is what completes the Tree.
=----(((((((((()----=
curlycord
- Status
Similar threads
