Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

firmware upgarde problems 1

Status
Not open for further replies.

IPStanding

Vendor
Dec 1, 2003
162
US
i have a prologix running CM 2 with a brand new CLAN and older Medpro. i am trying to upgrade the firmware for both boards but am having no luck. i login using binary and can get the files up there but they wont upgrade. i tried both signed and unsigned bins. i rebooted the PBX. i get a 513 aux 2 and 258 aux 1 error. i was able to do upgrades with the previous CLAN in this switch. any suggestions? i also got rid of all of the old clan programming and did a reset sys 1 then put all of the programming back.
 

Try these setting for Firmware Download Screen for a Self Download, changing the source board location.

change firmware download

Source Board Location: 01A10
Firmware Image File Name: tn799dp_f17-sig.bin
Target Board Code: TN799 Suffix: DP Firmware Vintage:
Schedule Download? y Remove Image File After Successful Download? y
Start Date/Time: 09/12/2005 13:30 Stop Date/Time: 09/12/2005 16:30
Target Target Target Target Target
Location Location Location Location Location
1. 01A10 11. _____ 21. _____ 31. _____ 41 _____
2. _____ 12. _____ 22. _____ 32. _____ 42 _____
3. _____ 13. _____ 23. _____ 33. _____ 43. _____
4. _____ 14. _____ 24. _____ 34. _____ 44. _____
5. _____ 15. _____ 25. _____ 35. _____ 45. _____
6. _____ 16. _____ 26. _____ 36. _____ 46. _____
7. _____ 17. _____ 27. _____ 37. _____ 47. _____
8. _____ 18. _____ 28. _____ 38. _____ 48. _____
9. _____ 19. _____ 29. _____ 39. _____ 49. _____
10. _____ 20. _____ 30. _____ 40. _____ 50. _____
Enter 5 character board number; cabinet(1-30):carrier(A-E):slot(0-20
 
I just had the same problem with a S8720 g650 pair last night.

Ended up putting a new CLAN with OLD firmware into the switch and then upgraded the medpro & Val (everything else was up to date).

Interestingly enough...I uploaded the new medpro firmware to the "broken" C-Lan card and ran the test (which had been formerly failing) and it passed. Like something got stuck in memory...
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top