Hey guys! I had to replace a damaged power module after a system failure and now i cannot enable XPEC. The system continuously display the following error FIR003 and FIR004. This prevents me from using the LD32 to enable xpec. how do i stop the FIR003 error?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations John Tel on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Fir003 error after system failure
- Thread starter pbxbabby
- Start date
- Thread starter
- #41
- Thread starter
- #42
- Thread starter
- #44
the figures on the display was changing constantly.....how ever i fount the problem. The new power supply that i installed was a rel 02 and the one that came out of it was a rel 03. I dont know if the release 3 provides more power but i got another power supply that is a rel 03. Once i installed the new power supply the fir003 error went away and i was able to enable the controller.
- Thread starter
- #45
- Thread starter
- #47
- Status
Similar threads
- Locked
- Question
- Locked
- Question