Fir003 error after system failure

[pbxbabby]

Hey guys! I had to replace a damaged power module after a system failure and now i cannot enable XPEC. The system continuously display the following error FIR003 and FIR004. This prevents me from using the LD32 to enable xpec. how do i stop the FIR003 error?

 

[pbxbabby]

i am connected remotely now but i was at the site last night and i have to go back today.

 

[KCFLHRC]

There is a whole troubleshooting section in that NTP but eyes on the problem may isolate the issue quicker than anything.

 

[pbxbabby]

ok do you have a link to NTP 553-3001-020

 

[KCFLHRC]

http://docs.smoe.org/nortel/47.249.32.115/docs/m1253x/5300020.pdf

 

[pbxbabby]

that the same one that i am working from see page 127 for the steps i sent you..

 

[pbxbabby]

my problem is that the controller card is disable and the system doesnt allow me to enable it.

 

[KCFLHRC]

It's not allowing you to enable the controller card because there is something else wrong, hence the FIR003 and 004 messages.

 

[pbxbabby]

Yeah, I am going back on site now. I just got fibre patch cords and new controller cards sent from head office. I am gonna replace the these items and see if the fir003 error stops.

 

[KCFLHRC]

This isn't one of those Fiber Remote Multi IPE's is it with the external fiber box? Or is it the one with the NT1P61 and NT1P62 cards

 

[KCFLHRC]

Have you done the XNTT test in LD 32 to test the NT1P61?

 

[pbxbabby]

Yeah NT1P61 in the network cab of the main system and NT1P62 at the remote IPE

 

[pbxbabby]

Nope I didnt do that one but i would love to try it now

 

[pbxbabby]

Is it LD32 => xntt loop?

 

[pbxbabby]

.stat 56

SUPER LOOP
DSBL RESPONDING
.xntt 56

TEST PASSED
FPEC CONNECTED

 

[KCFLHRC]

That looks good, could be misleading but I doubt it. That LBTN thing is kinda weird, not really a TN but a loopback channel. Have you tried entering the l1 s 99 or is that just bogus info in the book?

 

[pbxbabby]

Nope it wont take L1 s 99

plus i just saw this error:


BSD825


BSD0825
Controller card is disabled.
Enable the card before performing the test.
Severity: Minor

 

[pbxbabby]

Nope it wont take L1 s 99

plus i just saw this error:


BSD825


BSD0825
Controller card is disabled.
Enable the card before performing the test.
Severity: Minor

 

[KCFLHRC]

I think a power cycle on that remote shelf is in order

 

[pbxbabby]

I have powered down the remote ipe a few times and change controller cards, i am wondering if the fibre patch cords at the main site of the remote site may be faulty.

 

[KCFLHRC]

Kinda weird a patch cord would go bad. Do you have spare fiber strands to switch it to?