Finding a RDB or maybe an RLI 1

[lynmar]

I have a block of 100 DID's, out of them 15 are being stripped to a Line Side T-1 card 16-0-0-0 and going to a remote site. The ports are programmed as 500 sets. How do I find out how these are being stripped? Is it done through a RDB? Please advise..

 

[one234]

Hi,

What you could do is print a DN that is being "stripped". Look at the type of the DN and work from there.

Marc D.

No trees were killed in the sending of this message. However a large number of electrons were terribly inconvenienced.

 

[jjmcc2]

Hello, they are not being stripped. The lineside T1 is just extending the station to another location. As you will see you program them just like a 500 set when you print out the tn of one of the stations on the line side T1.

 

[lynmar]

Thank you for your responses, they helped.

 

[CommsResponder]

Have you done a call trace in LD-80 ????

Jaye.