Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fiber Pull

Status
Not open for further replies.
Apr 14, 2010
20
US
Just pulled in 3 runs of 950',600'and 350' at football stadium. pulled through provided underground conduits, to all buildings. Now need to terminate.
Looking for Current Rates.....
 
Your question isn't quite clear. Are you looking for the rate that you will pay to have another vendor terminate, or are you asking what you should charge your customer? Know that the fiber type and connector type will be pertinent.
Mike
 
Also where are you located.

Kevin Wing
ACSS Small and Medium Enterprise (SME) Communications
ACS- Implement IP Office
ACA- Implement IP Office
Carousel Industries
 
We would charge an hour per cable end to prep plus twenty minutes per strand to terminate, label and test. Plus termination hardware. Pulling is like pulling any other cable.
Mike
 
Depending on the number of strands, we usually charge a minimum of 4- hours for Fiber Optic termination. Yes, pulling fiber is the same as any other cable and you can get just about anyone to pull cable, however when it coems to terminating the fiber, the list of qualified fiber optic installers becomes very short.

Sal-





"Voice and Data Solutions
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top