Feature to select a specific Line

[nsanto17]

What is the feature to select a specific line on the BCM 400.

We just our T1 repaire and i only see a few lines in the BCM monitor. They are prop not showing up b/c they have not been used yet but i would like to test them to make sure they are working.

Thanks

nick

 

[acewarlock]

NONE

 

[norstarboy125]

What type of T1?

 

[gberger]

There's no feature code to access a specific channel on a PRI but if you want to test each channel go under -configuration-resources-telephony resources-PRI-then under the tab "provision lines" deprovision all the lines and provision them back one at a time starting with the first one(channel 1),that way you'll be able to test all channels.

 

[cigargerald]

As elementary as this might sound, this will allow you to see all of them.

Start dialing your own numbers, using (9+#), and place them on hold, answer them, and place them on hold again - using as many phones as necessary until you achieve a busy signal trying to get an outside line. Look at BCM monitor, and you can see and count them.

G-

 

[nsanto17]

I was able to solve my own problem. I just added the lines one by one on my phone and pressed the button associated with that line. When pressed i would be able to access that line and it will now appear in the BCM Monitor.

Thanks for all your replies.