Hi,
I'm using SAM to automate backup for my HP system. My questions are.
1) How can we sure the backup is successfull?
2.)How do we check the display the tape contain after fbackup?
3.) I have a autoloader install on my HP UX, can I set a command to change the tape once the 1st tape is full? If not, any recommend backup solution? Thanks !
KC
I'm using SAM to automate backup for my HP system. My questions are.
1) How can we sure the backup is successfull?
2.)How do we check the display the tape contain after fbackup?
3.) I have a autoloader install on my HP UX, can I set a command to change the tape once the 1st tape is full? If not, any recommend backup solution? Thanks !
KC