We have a branch office that will be connecting via DSL to our main office where the servers are. Our FB1000 v7.0 is between the internet and our servers. The DSL is dynamic IP and the servers are win2k sp3. The client machines at the branch office run win98SE. I'll be installing the L2TP/IPsec VPN client on the win98 machines.
What we need to do is to setup BOVPN using IPsec (we have a Netgear DG814 DSL modem at the branch office). The branch office is on a 10.50.6.x network.
But I have to confess that I have no clue what the settings should be. I am referring to the following:
For the Gateway: key negotiation type, remote ID type, gateway identifier, phase 1 authentication, phase 1 encryption, diffie-Hellman group, enable perfect forward security (yes or no), enable aggressive mode (yes or no).
For the tunnel (which is dependent on the key negotiation type): ESP or AH and what the settings should be.
And then there is Routing Policy...
I know it's a lot of info that I'm hunting for, but as a first-timer, there's always a learning curve. Thanks!
What we need to do is to setup BOVPN using IPsec (we have a Netgear DG814 DSL modem at the branch office). The branch office is on a 10.50.6.x network.
But I have to confess that I have no clue what the settings should be. I am referring to the following:
For the Gateway: key negotiation type, remote ID type, gateway identifier, phase 1 authentication, phase 1 encryption, diffie-Hellman group, enable perfect forward security (yes or no), enable aggressive mode (yes or no).
For the tunnel (which is dependent on the key negotiation type): ESP or AH and what the settings should be.
And then there is Routing Policy...
I know it's a lot of info that I'm hunting for, but as a first-timer, there's always a learning curve. Thanks!