Fax over IP on my AVAYA CM 6.3 System

[navyavayeng1]

I have been researching the web for solutions, and only found 1...that isn't working for me...
I have an AVAYA CM 6.3 running on G450's with 4524-GT's as our VOIP POEs.
Our main PBX feeds remote locations.
Once of the remote locations is fed by fiber only...
so I have an AVAYA POE switch (4524GT) to provide VOIP Phones.
There is no copper going to the building...and they have a fax machine.
The only device I found AVAYA tested compatibility with is: an Audio Codes MP 112 Voip Gateway.

http://downloads.avaya.com/css/P8/documents/003867578

Shows an interoperability test done in their labs.
The only issue I have is... I don't have AVAYA SESSION MANAGER.
Does anyone know of a way around this by using the MP112 device, or a Cisco SPA112 Device... something else?

Thanks!

 

[janni78]

Have you setup routing to CM in the Tel-IP routing table on the MP112?

"Trying is the first step to failure..." - Homer

 

[wontwork]

Hi,
I have set that up but it is not doing what I am expecting it to..

I was hoping to see some screenshots or output of a working scenario to compare against

Thanks

 

[sekitori]

Ok, fxs

 

[sekitori]

and fxo;

 

[wontwork]

thank you - I will check my settings against these and see where the issue lies.

 

[sekitori]

Also, make sure you have the correct call-progress-tones file and FXO-(or FXS)-coefficient-file loaded....

Sekitori