Mitelman3300
Technical User
System has been working ok, but after a recent powercut, card status Red, and error message Fault-unacc on the unified console. Tried another slot same problem. Suspect SLC8 card is faulty. any ideas?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Fault-unacc error on Kx-NCP500
- Thread starter Mitelman3300
- Start date
- Status
obtsystems
Programmer
Sounds like the card has blown. You can send for repair or replace
- Thread starter
- #3
Mitelman3300
Technical User
Yes that was my thought....First time I have had this with Panasonic though. Can you recommend a repair service?
obtsystems
Programmer
It would have to be sent back through a panasonic dealer to an approved repair centre.
I would replace it too, system can't be left down for the time it would take to fix and could come back beyond economical repair. or not much in price for new one
I would replace it too, system can't be left down for the time it would take to fix and could come back beyond economical repair. or not much in price for new one
- Status