DaveThePhoneDoctor
Vendor
MICS/NAM: NorstarTechChris sent me the FastRAD manual. Thanks Chris!
However I am just not able to understand the install and config procedure of the FastRad.
Now remember I read the manual after working all night til 3am.
I want to be able to set it up so I can connect remote via my office PC like I do for my Partner systems.
1-How is it connected:
FastRad unit to 9 pin cable then to 9 cable port ( there are two 9 pin ports ) on underside of NAM? Then station cable to FastRAD unit. Then station cable to any unassigned ext. or outside loop line?
2- How to set FastRAD unit for Auto Answer:
Do I Telnet to FastRAD unit via a PC then reset the AA. How do I check to see if the FastRAD unit is already set for Auto Answer ( can I place a call to it )
3-Once setup how can I log on after hours when the recp. is gone:
According to the installations inst. I can only use the Auto AA to route me to the FastRAD unit with Compact system. I have a MICS/NAM and it says that I must have the Recp. rout me to the unit ( what do I do after hours when the Recp. is gone )
I am a fast learner and this is only the 4th MICS//NAM I have worked on. I am planning on working on more. So far I am up to speed on everything else with MICS. I have never connected a FastRAD before.
I have to go over there today and could use some help to set this up so I do not have to keep running over there for every little change.
Thanks again Chris for the manual.
Dave,
The Phone Doctor
Las Vegas, NV USA
"You're Never Alone When You're Near A Phone!"
...Lily Tomlin
a/k/a "Ernestine
However I am just not able to understand the install and config procedure of the FastRad.
Now remember I read the manual after working all night til 3am.
I want to be able to set it up so I can connect remote via my office PC like I do for my Partner systems.
1-How is it connected:
FastRad unit to 9 pin cable then to 9 cable port ( there are two 9 pin ports ) on underside of NAM? Then station cable to FastRAD unit. Then station cable to any unassigned ext. or outside loop line?
2- How to set FastRAD unit for Auto Answer:
Do I Telnet to FastRAD unit via a PC then reset the AA. How do I check to see if the FastRAD unit is already set for Auto Answer ( can I place a call to it )
3-Once setup how can I log on after hours when the recp. is gone:
According to the installations inst. I can only use the Auto AA to route me to the FastRAD unit with Compact system. I have a MICS/NAM and it says that I must have the Recp. rout me to the unit ( what do I do after hours when the Recp. is gone )
I am a fast learner and this is only the 4th MICS//NAM I have worked on. I am planning on working on more. So far I am up to speed on everything else with MICS. I have never connected a FastRAD before.
I have to go over there today and could use some help to set this up so I do not have to keep running over there for every little change.
Thanks again Chris for the manual.
Dave,
The Phone Doctor
Las Vegas, NV USA
"You're Never Alone When You're Near A Phone!"
...Lily Tomlin
a/k/a "Ernestine