Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fast Busy can only be reset by removing T1 Main Cable and plugging back in

Status
Not open for further replies.
solidtechnw

solidtechnw

IS-IT--Management
Aug 4, 2014
2
US
We have an MX200 that we are planning on replacing shortly as it is EOL EOS. As we are a cisco VOIP shop we have been waiting until we moved over to some new SIP trunks. Oddly the system is going into a State of Fast busy that can only be resolved by Physically disconnecting the T1 cable from the controller and plugging it back in. This resets the system. We have had several times as well when we have had to do a complete shutdown / restart. From our end we have fluke tested the CAT5, and verified the T1.

Ideas?
 
Status
Not open for further replies.

Similar threads

A
  • Question
Hardware reset for Unify OpenScape Business x8
Replies
1
Views
84
sbcsu
sbcsu
fishhead64
  • Locked
  • Question
6920/6940 default back to main screen?
Replies
1
Views
103
Billz66
Billz66
fishhead64
  • Locked
  • Question
Revolutions - Filter alerts by property
Replies
2
Views
133
fishhead64
fishhead64
voipneerd
  • Locked
  • Question
Mitel Mx one password reset
Replies
1
Views
120
nytalkin
nytalkin
sadic
  • Question
cannot redial ip phone but analog can
Replies
5
Views
468
sadic
sadic

Part and Inventory Search

Sponsor

Back
Top