I have a report: Manager - drilldown to Project Type - drilldown to Details. For Managers I have report name on the page header (which is OK). For Project Type paret I need a different header and for Details also.
How could I do this??
If you have Crystal 9...you can have the 3 Headers hold different labels...then, in the Section Expert of each header (other than GH1) you can put in the X-2 --> drilldowngrouplevel <> 2
the number will be at the drilldown level that you WANT to see that header...
if you don't have crystal 9, you will have some problems with formatting....
Hide/Drilldown OK on GH1....
when you click on GF2, you will have the GH1 and GH2 showing on the second level...to avoid this...
go to the section expert of GH2 and where there is the supress option....don't check it but go into the X-2 formula section and put in DRILLDOWNGROUPLEVEL <> 1....
This will only show the GH2 when you are at the detail level...
try it and let me know if you can get it to work...
I open the report and see:
Report name
A.Smith
B.Lake
C.Taub
D.Halk
Then click on B.Lake and I want to have
Report name
B.Lake
Type1
Type2
Type3...
In reality I do not see Report name over B.Lake.
You said you found a different way to show a page header when drilling down in a report in your July 10th note but you did not specify how you did this. I need to do the same thing. Can you let me know how you did it?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.