Factory Default 4621sw

[pronei]

Does anyone know how to reset a 4621SW during the boot sequence?

I need to CLEAR the phone as it has bad VLAN settings, but can't find a way to get into the programming menu during boot.

I can't MUTE CLEAR# or RESET# as the phone is stuck looking for DHCP in a non existant VLAN.

Is there a button sequence during startup that will allow me to wipe the phone?

http://www.linkedin.com/in/neil74/

 

[smokinjoe2938]

try unplugging phone and back in and hit * when prompted for programming

acss sme acis sme acss cm 5.2.1 acss cm and cmm acss aura messaging.

 

[pronei]

There is no *, It's stuck in a hard coded VLAN (used phone from another location that was moved) and apparently the:
SET OPSTAT
SET PROCSTAT
SET PROCPSWD
in the 46xxsettings.txt did not allow for * during boot.

I didn't know if there was a keypress combo that can be done during startup to CLEAR / Default the phone or if I'll have to build a temporary VLAN & DHCP Scope to accommodate the phone then run a CLEAR on it.

I'm hoping there is a boot time keypress sequence.

http://www.linkedin.com/in/neil74/

 

[JayNEC]

Nope. You're going to have to setup an environment temporarily to let you get into that phone.

New England Communications

http://www.necomm.com